Door Exit Sensor System

The Economy CordLess Exit Alarm is simple to use and works with all 433 CordLess Sensor Pads & Mats, Nurse Call Buttons, and Motion Sensors.

Monitor can be mounted away from the bed, removing in-room alarm noise and reducing entanglements and tripping hazards. Adjustable volume and gentle chime alert won’t startle residents and offers QUIETER fall prevention.

The Window/Door Exit Alarm can be mounted to a window or door frame using the provided mounting hardware or adhesive tape. When the window or door opens the contact magnet is separated from the sensor, a wireless signal is sent to the cordless alarm to alert the caregiver.

• Place on door jam and know remotely when the door is open.
• Low cost anti-wandering solution.
• Know when at risk patient is walking away.

System includes wireless door/window exit alarm and cordless alarm.

(Possibility to add multiple doors/windows with the following guidelines)

433-EC

1. Start with the 433-EC monitor in the OFF position.

2. Press and hold a paper clip or other small tool into the program buttonhole on the back of the monitor until the 2 outer LED lights in the red window flash, then turn solid red.

3. As soon as the lights turn solid red, remove the paperclip. The lights should stay solid red when you remove the paperclip.

4. Activate your component.

Example:

• Apply pressure to the bed/chair cushion for a few seconds, then release.

• Stand on the floor mat for a few seconds, then get off

• Turn on the motion sensor and wave in front of it (433-MS).

• Press and release the call button (433-NC).

• Separate the parts from the exit alarm (433-EXT).

5. If you have more than one component to program, repeat step 4 until all components are activated. If you have finished activating your components, continue to step 6.

6. Quickly press the paper clip into the program button and remove it, do not hold the paper clip into the program button. The top lights should flash and then turn off.

7. Test your products: Turn on the 433-EC monitor (CHIME mode) and activate your component.

**If programming a bed/chair cushion or floor mat, make sure the transmitter is turned on before programming**